Ink Cartridge Series

Ink Cartridge Series

How to open the Dell series 9 ink cartridges?

I try to recycle my ink cartridges and I have all the ink and stuff, but I can not find how to open the cartridge! I need to get to work once you open it! Is that where I drill a small hole in the top? If yes, where to put the hole? I can not find my instruction book and have already paid for the ink refill speand not really want any more money than someone else do it.

Step 1) Put the cartridge on paper towels in an area where we can tolerate a spill. Step 2) Using 1 / 16 inch drill, drill a hole in the upper surface flat bottom - 1/3rd of the way to the edge. Make the hole where the letter "E" Dell is molded into the surface. TIP: You can take a large paper clip, unfold, and heated in a flame to melt a hole instead of using a drill. Step 3) Keeping the cartridge on paper towels, take a bottle filling syringe and 1 / 3-1 / 2 full of ink - about 10-15 ml. Step 4) Insert the needle into the hole. Get the tip of the needle down the cartridge. Inject the ink very slowly and watch until the sponge is saturated. You should get the needle deep into the sponge hard. Step It is not necessary to seal the hole. Step 9) Set above a paper towel for an hour as a precaution drop drop. Wait a few drops. Do not let the cartridge to touch the paper towel at this point, since the towel will draw out the ink. Step 10) To better results, let sit overnight before use. The tape over the vent hole, if you save for several days to prevent drying ink.

Reseting Canon IP and MP Series Printers